Before shooting, have your gun checked by a gunsmith.
Use BLACK POWDER ONLY
1) PRIMING : Place the primer on a flat, hard surface.
Position the base of the empty cartridge case over the primer, and the
kit's extractor rod into the bottom of the case: strike the rod with a
mallet.
2) Charge the case with a measure of black powder.
3) Place the case on the tool base and then put a bullet head on the top of
the case. Cover with the main tool, groove-marked end downward.
4) Adjustment of the seating tool:
With a mallet, force the bullet
head progressively into the case until it is shoulder deep.
Screw the
bushing down against the main tool and fix it in place with the nut.
5) Crimping : put the support washers
into the tool base. Put the cartridge above the supports.
Cover the
whole with the main tool, groove-marked and downward.
Strike with a
mallet until the main tool comes into contact with the tool base.
NB: For crimping, instead of the mallet a vice can be used.
AFTER SHOOTING : 6) Deprime the case with the deprimer.
Clean the case with a solution of water and detergent.
7) Lubricate the case and re-size it.
8) Put the case out of the resizing die using the extractor rode and the mallet.
The case is now ready for reloading.
The use of other propellants is done entirely at the user's own risk.
If you intend using other propellants, consult a GOOD reloading manuel first.
Before shooting, have your gun checked by a gunsmith.
Use BLACK POWDER ONLY
